![]() Solder mats like this are a good size (35x25cm) for smaller electronics repairĪs for esd, just be careful, discharge large/high voltage caps with a screwdriver Most important, always discharged yourself before touching the PCB.Īgreed, those suck, not only useless for doing any work (screws fall through holes and solder sticks to it), they degrade also melt other plastics Use isopropyl alcohol at least 70% to clean the contact, so that it doesn't create small water on the PCB. Flex ribbon is very fragile, so don't pull it too hard. That flex connector in the controller is far worst I have ever seen. Originally posted by Jamebonds1:Also, don't use a mat like one in the video. ![]()
0 Comments
Leave a Reply. |